specification model dc voltage rated current current range rated power output voltage adj. range line regulation load regulation setup, rise time hold up time (typ.) voltage range frequency range efficiency (typ.) input inrush current (typ.) leakage current safety standards working temp. working humidity storage temp., humidity temp. coefficient vibration mtbf dimension others note packing overload over voltage battery low ac current (typ.) 1000ms, 90ms/230vac 2000ms, 90ms/115vac at full load 24ms/230vac 20ms/115vac at full load 88 ~ 264vac 124 ~ 370vdc 47 ~ 63hz 80% 84% 84% 2.5a/115vac 1.5a/230vac cold start 20a/115vac 40a/230vac <1ma / 240vac ch1:105 ~ 135% ch2:0.51 ~ 0.9a rated output power ch1:15.87 ~ 18.63v 10v 0.8v 19.5v(+1.5v,-1v ) 39v 2v ch1:31.74 ~ 37.26v ch1:62.1 ~ 72.9v protection type : shut down o/p voltage, re-power on to recover ul60950-1, tuv en60950-1 approved compliance to en55022 (cispr22) , class b en61000-3-2,-3 compliance to en55024, light industry level, criteria a en61000-4-2,3,4,5,6,8,11, -10 ~ +60 (refer to "derating curve") 20 ~ 90% rh non-condensing -20 ~ +85 , 10 ~ 95% rh 0.03%/ (0 ~ 50 ) 10 ~ 500hz, 2g 10min./1cycle, 60min. each along x, y, z axes 183.3k hrs min. mil-hdbk-217f (25 ) 199*110*50mm (l*w*h) 0.88kg; 16pcs/15kg/0.95cuft power factor (typ.) pf>0.92 at full load 155w single output with battery charger(ups function) universal ac input / full range protections: short circuit / overload / over voltage battery low and battery polarity protection cooling by free air convection 100% full load burn-in test fixed switching frequency at pfc 67khz, pwm 134khz 2 years warranty features : a d - 1 5 5 s e r i e s ripple & noise (max.) note.2 voltage tolerance note.3 environment safety & emc (note 4) protection withstand voltage isolation resistance i/p-o/p:3kvac i/p-fg:1.5kvac o/p-fg:0.5kvac i/p-o/p, i/p-fg, o/p-fg:100m ohms / 500vdc / 25 / 70% rh 1. all parameters not specially mentioned are measured at 230vac input, r ated load and 25 of ambient temperature. 2. ripple & noise are measured at 20mhz of bandwidth by using a 12" twisted pair- wire terminated with a 0.1uf & 47uf parallel capacitor. 3. tolerance : includes set up tolerance, line regulation and load regula tion. 4. the power supply is considered a component which will be installed into a fi nal equipment. the final equipment must be re-confirmed that it still me ets emc directives. for guidance on how to perform these emc tests, please refer to ?emi testing of c omponent power supplies.? (as available on http://www.meanwell.com) ch1 output number ad-155a ad-155b ad-155c 13.8v 13.3v ch2 27.1v ch2 53.5v ch2 27.6v ch1 54v ch1 10.5a 0.5a 0.5a 0.2a 5a 2.7a 0 ~ 11.5a 0 ~ 0.5a 0 ~ 0.5a 0 ~ 0.5a 0 ~ 5.5a 0 ~ 2.7a 151.55w 151.55w 156.5w 150mvp-p -------- -------- -------- 150mvp-p 240mvp-p ch1: 12 ~ 14.5v ch1: 24 ~ 29v ch1: 48 ~ 58v 2.0% -------- -------- -------- -------- -------- -------- -------- -------- -------- 1.0% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% protection type : ac charging mode : constant current limiting, recov ers automatically after fault condition is removed ups mode : protected by internal fuse emc immunity emc emission file name:ad-155-spec 2011-06-16
mechanical specification derating curve output derating vs input voltage (a) file name:ad-155-spec 2011-06-16 case no. 906b unit:mm ambient temperature ( ) load (%) input voltage (v) 60hz 90 88 100 120 140 160 180 200 220 240 264 100 90 80 70 60 50 40 load (%) -10 0 10 20 30 40 50 60 70 20 40 60 80 100 with 21.6 cfm min.(10cm) with no fan +13.8v (horizontal) block diagram pwm & pfc circuit detection o.l.p. emi filter rectifiers circuit power switching filter & back up rectifiers bat.charger +v b+ reset -v i/p fg control o.v.p. & pfc constant current limiting & start circuit active pfc fosc : 67khz pwm fosc : 134khz terminal pin no. assignment pin no. pin no. 12 5 34 67 8 assignment assignment bat. + bat. -/com dc output com dc output +v fg ac/l ac/n nc 20 159 199 6.5 20 3.5 25 3-m3 12 37 100 172 192 5-m3 97 3.5 190.5 24.5 16.5 3.5 50 6 110 8.2 9.5 12 78 6 5 4 3 2 1 6 5 1 2 cn1 pin no. assignment mating housing jst xhp or equivalent terminal jst sxh-001t-p0.6 or equivalent 12 reset sw cn1 pin no. assignment :jst b2b-xh or equivalent a d - 1 5 5 s e r i e s 155w single output with battery charger(ups function)
|
